Hard Reset EVERTEK EverGlow D40

EVERTEK EverGlow D40 Hard Reset is a device reset to factory settings. This operation deletes all data, settings, passwords and applications in the memory device. Hard Reset operation is most commonly used to repair a damaged or malfunctioning equipment or deletion of user data before the sale. Hard Reset operation will wipe all data, bypass screen lock and restore device software to factory state.

How to hard reset EVERTEK EverGlow D40?

  1. If you decided to perform Hard Reset on your EVERTEK EverGlow D40, you have to, firstly, turn it off, by holding Power Key for a couple of seconds.
  2. After your device turns off completely, you have to hold down combination Power Key + Volume Up for about 10 seconds to proceed to the Recovery Mode.
  3. If Android robot icon appears, press Power Key + Volume Up once to proceed.
  4. Next you have to select option wipe data/factory reset“, use Volume Keys to navigate to it and Power Key to select it.
  5. Confirm this opeartion by selecting “Yes — delete all user data”.
  6. Wait for data wipe to complete, and then select option reboot system now“.
  7. Your EVERTEK EverGlow D40 will be restarted in a few minutes and that’s it, congratulations.

Finish! Your device will have the software and set of applications as the moment they leave the factory.

*Take a backup: Before you can use Hard Reset always remember to make copies of your data, because the operation is irreversible and recover previous data and settings will not be possible.

*Caution: Using the Hard Reset is safe and should not cause any damage. However, you need to make sure the device has over 30% battery so the process does not stop halfway.

Inline Feedbacks
View all comments