Hard Reset EVERTEK EverStar Pro

EVERTEK EverStar Pro Hard Reset is a device reset to factory settings. This operation deletes all data, settings, passwords and applications in the memory device. Hard Reset operation is most commonly used to repair a damaged or malfunctioning equipment or deletion of user data before the sale. Hard Reset operation will wipe all data, bypass screen lock and restore device software to factory state.

How to hard reset EVERTEK EverStar Pro?

  1. If you decided to perform Hard Reset on your EVERTEK EverStar Pro, you should turn it off, by holding Power Button for a couple of seconds.
  2. After your device turns off completely, proceed to the Boot Mode, by holding combination Power Key + Volume Up for about 5 seconds.
  3. In Boot Mode, use Volume Up key to navigate to option Recovery Mode and select it with Volume Down.
  4. After Android robot appears on screen, press Power Key + Volume Up + Volume Down once to proceed to Recovery Mode.
  5. Next, use Volume Keys to navigate to option “wipe data/factory reset” and then select it with Power Button.
  6. Confirm this operation next by selecting “Yes”.
  7. Wait for a few seconds for data to wipe, and then select option “reboot system now” to exit Recovery Mode.
  8. After that your EVERTEK EverStar Pro will be restarted in a minute or so and that’s it, well done.

Finish! Your device will have the software and set of applications as the moment they leave the factory.

*Take a backup: Before you can use Hard Reset always remember to make copies of your data, because the operation is irreversible and recover previous data and settings will not be possible.

*Caution: Using the Hard Reset is safe and should not cause any damage. However, you need to make sure the device has over 30% battery so the process does not stop halfway.

Inline Feedbacks
View all comments